Straw Choppers are available with or without the drive system for both the 20 series and the 9000 series model John Deere combines. TSR choppers are an OEM match.
TSR Fine Chop straw choppers are available with or without drive for both the 20 series and 9000 series model John Deere combines. The TSR Fine Chop straw chopper is original to TSR Parts and differs from the John Deere OEM Fine Cut.
TSR has added a wide spread deflector assembly to fit all STS John Deere combines.
To our current line of replacement straw choppers for John Deere combines we have added fine chop straw chopper units for finer chopping in small grains and soybeans. Our 9000 series fine chop straw choppers also include the Extra Wide Spread Kit. These fine chop straw choppers are available with or without a complete drive.
Update your combine with straw spreader to a new straw chopper kit from TSR Parts, Inc. all mounting hardware and installation instructions are included with the kit. Units are available for 20 & 9000 Series combines, fine chop or standard rotor.
AXIAL FLOW COMBINES 1981 & NEWER MANY FEATURES MAKE THE TSR STRAW CHOPPER SUPERIOR TO THE OEM STRAW CHOPPER
Stationary Knives are extra long for fine chopping
Knives can be adjusted from the outside of the combine
Greaseable bearings
Blades on rotor swing to let weeds or slugs clean out without damaging knives
Straw chopper has High & Low speed for varying crops
Gearbox drive
Maintain original appearance of machine
Does not impede access to sieves
Quality construction
MADE IN THE USA
TSR straw choppers for Case IH combines are available with or without a drive system for 60, 80, & 88 series. Component parts are available for all model straw choppers and are an OEM match excluding the TSR Fine Chop straw chopper and the TSR straw choppers for IH combines.
Improve the performance of your AXIAL FLOW CASE IH combine by adding the TSR Straw Chopper. Kit includes Straw Chopper Unit with Rotor, Gearbox Tower, Pulleys, Belts, Shields. Exchange of Pulley is Required.
The TSR Straw Chopper for Case IH axial flow combines is designed to enhance the performance of the machine. The hammers on the chopper rotor push material through an extra long stationary knife and produces finely chopped residue for better distribution. The chopper mounts in place of the beater assembly and uses its own drive, which is included.
The straw chopper has 2 speeds:
HIGH 2600 RPM for chopping small grains and beans
LOW 1600 RPM for operation in corn
The stationary knife bank can be retracted from the outside of the machine. This would be done for operation in corn or if the operator wanted to bale the straw. The chopper assembly is designed to fit with little or no modification to the combine. There is no cutting or drilling required for installation.